Technical Forum | Technical support | en_IT Emuca Back to top
emuca - vida en los muebles

You are going to delete this cart. Are you sure?

Accessing the private area Emuca - Vida en los muebles

Technical Forum

We want to clear up the main technical doubts that may arise regarding the assembly of our products and the necessary steps required to assemble them.

Hinges, stays and latches

Yes, the hinges and accessories come with Ø4x16 mm screws with the same titanium finish. The screws are also available for sale separately (cod. 5039752).

We also have decorative panels in both long and rounded hinge formats with the same titanium finish for full integration in the unit.

Depending on the overlap you can choose one of these hinges:

Full overlay hinge: If you want to overlap practically the full side of the unit.
Half overlay hinge: If you want to overlap half the side of the unit.
Insert hinge: If you want the door to be inlaid hand therefore for the side of the unit to be seen.

What type of concealed hinge do I need to choose depending on the door overlap that I want to achieve?

Once you have chosen the type of hinge that you are going to use (straight, elbow or super elbow) you will have a formula for calculating the base or plates. This formula will the type B = 14 + D - O, where the variables are:
B = Height of the base or plates.
D = Drill distance from the hinge.
S = Door overlap with the side.

For example: We have a door with a thickness of 22mm, an overlap with a side of 15 mm (S) and a distance from the drill of 3 mm (D), we also know that the thickness of the unit board is 16 mm.
As the overlap is large, we will use the straight hinge. The formula of the straight hinge is B = 14 + D - O. We know the values D = 3 and S = 15. Replacing in the formula: B = 14 + 3 - 15 = 17 - 15 = 2.
So B = 2, with the straight hinge and the base is 2mm, the problem is solved.

How can I calculate the base or ideal plates for a concealed hinge?

The quantity of hinges needs for each door will depend on the width and height of the door, as well as the material that it is manufactured out of. In fact, it can vary in some specific cases.

The adjoined diagram can be used as a reference. where L is the distance between the hinges.

How can I know the number of hinges needed for a door?

The supplements or bases that are used along with the hinges have two holes for fastening to the furniture and a third hole for increasing the resistance of the hinge/supplement joint. It is especially designed for facilities that require more resistance such as on doors with pistons. 

In the following table you can see the length of the hinge arms on the side of the unit:

What is the length of the hinge arm on the side of the unit?

The main function of an unsprung hinge is to allow the use of push pieces to open the door with a push system in order to ensure a smoother opening of the door without the inertia generated by an inverted hinge.

It can also be used in combination with soft-close hinges on doors with a great number of hinges in order to accelerate the closing speed of the door, since they are compatible with the entire X91 hinge family.

Technical questions box

You can not find the information you need? Raises your technical questions about our products and our technical department will solve.