You are going to delete this cart. Are you sure?
We want to clear up the main technical doubts that may arise regarding the assembly of our products and the necessary steps required to assemble them.
Yes, the drawer measurements, including its dimensions and machining, are fully compatible. The board cutting measurements, mounting dimensions and placement of the drawer in the module are exactly the same.
This allows customers to mount 30 kg Concept slides and 50 kg slides on the same drawer.
It is only necessary to connect the machine to air with a pressure of 7-8 kg/cm2.
The RAL code of the anthracite grey finish of the sides of the Concept kitchen, household and bathroom drawer is approximately 7043.
The RAL code of the white finish of the sides of the Concept kitchen, household and bathroom drawer is approximately 9003. Although it is necessary to bear in mind that the white silk colour of said drawer is metallized and the RAL codes are for flat colours.
Due to the fact there is separate assembly on the drawer, you can mount the Concept rails on other models of drawers. However, it is not advisable, as each drawer has its own rails and its own machining distances.
In order to assemble a Concept type kitchen drawer with hinges on the unit doors (hinged doors) it is necessary to use hinges with an opening angle of 165ª or to use spacers, doing so means there will be enough space to pull out the drawer.
Yes, the Lokbox mechanism is used to fasten the bottom of the drawer to the front part without preventing adjustment of it. It is compatible with the Concept, Slim and Vantage-Q drawers or any drawer. It is especially recommended for very wide drawers used in the furnishings of kitchens, bathrooms, lounges and even inside wardrobes. However, you need to take into account that the installation dimensions change. See diagram.
You can not find the information you need? Raises your technical questions about our products and our technical department will solve.