This model incorporates a total synchronised extraction system that provides a smooth and silent glide.
The eccentric adjustment of the front panel allows adjustments of ±2 mm vertically and ±1 mm horizontally, facilitating precise alignment.
Kit includes 1 set of slides, 1 set of ribs, 1 set of drawer front clips and screws.
The RAL code of the anthracite grey finish of the sides of the Vertex drawer is approximately 7043.
The RAL code of the grey finish of the sides of the Vertex drawer is approximately 7045.
The RAL code of the white finish of the sides of the Vertex drawer is approximately 9003.
At Emuca, we make it easy for you. Here you can download this Excel file that will help you configure your drawer unit step by step. Simply enter the module measurements (height, thickness, overlap, etc.) and specify how many drawers you want. This file allows you to:
Automatically calculate the machining dimensions of the drawer fronts (H1, H2, H3...) (mm).
Determine the height of each drawer front (mm).
And obtain the machining dimensions required to manufacture the drawer fronts (X, Y) (mm).
It also includes visual representations so you can check the result and avoid errors. Ideal for carpenters, designers or DIY enthusiasts who want a practical and accurate solution.
If a warning message appears when you open the Excel file, close the file. Right-click on the downloaded file and select Properties. At the bottom of the window, tick the box Unblock. Click Apply and then OK. You can now open the file.
The 131 mm high Vertex Push Sincro external drawer has a maximum load capacity of 40 kg.
It is recommended to use the synchronising rod (code 3202261, not included in the kit) for widths over 600 mm.
Yes, without any problem. However, if the drawers are wider than 600 mm, and in order to guarantee a correct opening of the drawer when pressing on any point of the front of the drawer, it is recommended to mount it.
The rod is supplied with a length valid for modules of 1200 mm, with a side thickness of 16 mm, and can be cut to the size required for our assembly.
No, the minimum installation depth is the same. Drawer depth + 5 mm
