Back to top
Loading…
emuca - vida en los muebles

You are going to delete this cart. Are you sure?

Accessing the private area Emuca - Vida en los muebles

Technical Forum

We want to clear up the main technical doubts that may arise regarding the assembly of our products and the necessary steps required to assemble them.

Castors, feet and table legs

Given that the unit load of each wheel is 70 kg, the complete Slip Ø100 4-wheel kit will withstand a weight of 280 kg.

In order to know if a nut is compatible with a leveller, we have to look at the internal thread of the nut and at the thread of the leveller, which must coincide.

For example, if we choose a 4 metric screw thread (M4), the nut also has to have an internal metric thread of 4 (M4).

In order to assemble the plastic base for the fridge, such as the Fridge Base, it is necessary to have the kitchen Bone feet as well as the number 10 metric screw thread (M10) from the same family, as the base as four holes for fastening the feet.

The Fridge Base is also perforated for ventilation and designed for fridges to be integrated into 600 mm wide units with tufts for assembly.

Yes, it is possible to cut the 80 and 60 steel feet. To do so, you need to cut the foot at the leveller part, once this part has been disassembled, and make the cut with a cutting disk/saw that is suitable for steel. Adjust the speed and the process in order to avoid deformation of the pipe.

 The following diagram shows the detail of the machining that you need to carry out on the table top of a table in order to fasten the plate of the 60 - 80 feet. It also shows the different machining for codes 3053632’5 and 3061625.

What is that machining that I need to carry out on the table top of a table in order to fasten the plate of the 60 - 80 feet?

The maximum recommended tabletop that the board or table top with Hera feet should have is 900 x 900 mm.

The maximum recommended tabletop that the board or table top with Duplo feet should have is 1.500 x 900 mm.

The maximum diameter that a table top or surface of a table can have with a Stay 5 or Stay 6 leg in order to avoid it toppling over when we support ourselves on one end is:

- 1,000 mm for the Stay 5 legs.
- 1,200 mm for the Stay 6 legs.

What is the maximum diameter of the table top surface of a table with Stay 5 or Stay 6 legs?
Technical questions box

You can not find the information you need? Raises your technical questions about our products and our technical department will solve.